iPhone6 Plus can't be charged and WiFi can't be connected. Replace the USB chip. After PAD Jump wire patching, the two faults are perfectly repaired.
iPhone 6 plus screen flower screen repair After testing, it was found that Nand was the problem. After replacing Nand,Nand was repaired.
The screen failure of iPhone 6 plus mobile phone was found to be caused by the disconnection of M1 pin of black touch chip. It was repaired directly after flying the wire.
The iPhone 6 plus cannot be turned on because of water. Clean the corrosive components and replace the display base. The power on is normal.
The iPhone6 Plus screen does not display, the detection is found to be inductively broken, and then replace the chip again, power-on troubleshooting.
iPhone6 Plus expansion causes the brush to fail, replace the new hard drive, replenish the capacitance around the hard disk, repair and repair.
iPhone 6 Plus mobile phone screen failure, the compass cannot be used, the motherboard is more disconnected, and the fault is perfect after the flying line.
iPhone 6 Plus screen is black or frozen mobile phone turns on Plus, tests VCC to be normal at 1.78V, determines the disconnection, and goes directly from the test point Jump wire to C2# of PAD, which can display normally after the power-on test.
iPhone 6 Plus mobile phone black screen can't open the machine brush to report the wrong 4005, it is caused by the damage caused by the CPU cap, and the problem is repaired.
